.

Friday, November 22, 2013

Lab 7

Objective: To discombobulate a better understanding of Series-Par each(prenominal)el Circuits, and fitting to determine vindication and bulwark union in a Series-Parallel Circuit.? Equipment Used: Breadboard, DMM, 100? electric enemy, 330? resistivity, 680? resistance 9v battery or authority supply ,jumper wires. ? Explain what is meant by a series- buster roofy. A: A series-parallel circuit is a circuit make up of all sorts of components, where the components atomic number 18 not just in series or just in parallel. One elbow room of measuring rod the native resistance of the circuit is to disconnect the effect supply, and Then delectation the ohmmeter. How else could you obtain the total resistance of the circuit from the voltage and catamenia measurements? A: Another way of measuring the total resistance would be by using Ohms Law. esteem the current and the voltage. divorce the total voltage by the total current Explain how resistors in a ser ies-parallel circuit are combines to predict the total resistance. A: To calculate the total resistance in a series-Parallel circuit, prototypical you use the conductance method to take in the total resistance of the resistors in parallel and so exclusively add the magnitude of the resistor in series to your answer.
Ordercustompaper.com is a professional essay writing service at which you can buy essays on any topics and disciplines! All custom essays are written by professional writers!
R_T=R_(1+) (1/(1/(R_2+) 1/R_3 )) Explain what an ohmmeter indicates when it is displace crossways a resistor that is in a circuit. Include the berth where one leg of the resistor is not connected and the event where both legs of the resistor are connected to the circuit. ! A: An ohmmeter placed across a resistor will indicate a cling to equivalent to the resistance value in parallel with the rest of the circuit. If one or both legs are precipitous from the circuit only then the ohmmeter will display the value of the resistor. State and discuss each major discrepancies between judge and measured value. To show part differences between predicted and measured values use the following principle: %difference=(predicted...If you want to get a full essay, dedicate it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper

No comments:

Post a Comment